PC Products 60th Anniversary

Read a great article on how to restore pottery, ceramics, porcelain and sculptures. See how the PRO's do it using our products!

Click Here



Recommend-a-lator 3000 Where to Buy!
Enter your email address to receive our
free tips, tricks and product news!



Unlock the Lost Videos!

products
paste epoxies

PC-AutoBond

For all your auto bonding needs!

pc-auto-bond

Description:
PC-Auto Bond™ is fast curing, strong and flexible cold weld Epoxy formulation. Product can be applied using a mixing nozzle or mixing stick. PC-Auto Bond™ is an extremely flexible epoxy with exceptional tensile adhesion and peel strength to a wide variety of substrates. In just a few minutes PC-Auto Bond™ forms a tough bond without the need for clamping and exhibits superior shatter, impact and vibration stability and resistance.

Added flexibility creates high strength, permanent bond.

print

Directions:
Prep surfaces by roughing up and making sure surface is clean and free of dirt, oil, rust, etc. Do not subject cured epoxy to heat over 300o F.

  • Remove cap from end syringe (twist).
  • Depress plunger evenly to dispense equal amounts of resin and hardener.
  • MIX THOROUGHLY ON A FLAT SURFACE. Or attach mixing nozzle and depress plunger to mix product.
  • Replace cap.
***Note: Use Nozzle or Hand Mix: If using nozzle for application, once finished, remove nozzle and replace cap on the end of syringe. Store for future use.

Application Limitations - Maximum temperature range:
250°F (121°C) continuous
300°F (149°C) intermittent.

Additional Information

Available Sizes:

  • UNIT SIZES
  • PART #
  • PURCHASE LINKS
  • 1 oz.
  • 081112
  • Grainger  Home Depot  Buy From The Paint Store  Amazon Supply

PC-Auto Bond™ has hundreds, if not thousands, of uses.

Bonds: PC-Auto Bond™ may be used as a general purpose adhesive to bond, all metals, fiberglass, PVC, wood, glass and many hard plastics. It forms a water resistant bond and is tough enough to be drilled, tapped, filed and sanded after final cure. Will not bond to polyethylene, vinyl, acrylics and some plastics. Test area when in doubt.
View All Uses

Physical Properties

  • Form:
  • Two Part Paste
  • Mixed Color:
  • Metallic Gray
  • Density:
  • 1.17 gm/cm
  • Work Life (75°F):
  • 8 minutes
  • Service Time (500psi 75°F):
  • 60-90 minutes
  • Full Cure (75°F):
  • 12-24 hours
  • Hardness Shore D:
  • 75
  • Lap Shear Tensile:
  • 1,700 psi
  • Compressive Strength:
  • 4685 psi
  • Shrinkage:
  • <1%
  • Insulation Resistance:
  • 30,000 megohms
  • Dielectric Strength:
  • 300 volts/mil

Technical Data