Emergency Repairs Safe For Potable Water Contact
PC-Plumbing™ is a hand moldable putty epoxy designed for quick emergency-type repairs. PC-Plumbing™ is NSF® rated safe for contact with
potable water. PC-Plumbing™ can be applied to wet and dry surfaces. Cut, mix and apply. PC-Plumbing™ allows a working time of about 3
minutes and cures for service in 60 minutes.
***Note: PC-Plumbing™ will not bond to wax paper, Teflon®, Polyethylene, and some other plastics. There are hundreds of plastics in
thousands of combination. Test a small area when in doubt.
Cut or twist off desired amount of epoxy. Mix by kneading putty with fingers until a uniform color is achieved. For ease of mixing
warm putty to room temperature or above. Powder on hands (corn starch, baby powder) is helpful to minimize sticky epoxy contact
before hardening begins.
*** Use latex gloves to avoid any issues.
- UNIT SIZES
- PART #
- PURCHASE LINKS
For best results, surface should be cleaned and free of rust, dust, and oil. Solvents such as denatured alcohol can be used to
remove most contaminants. Whenever possible, lightly sand or rough up the surface to improve adhesion. For a smooth, finished surface,
hand rub with wet finger or cloth prior to cure. Denatured alcohol is excellent for smoothing, shaping, and forming of putty epoxy.
PC-Plumbing™ cures well even at cold temperatures (40°F). PC-Plumbing™ is supplied in premeasured sticks. The texture of the putty
is such that it is slightly tacky but does not stick aggressively to fingers. The putty holds its shape well and can be used in vertical and overhead applications.
Wrapped in Polyethylene film and protected on the ends with aluminum labels, the stick is doubly protected in an air tight clear
plastic cylinder. The remaining portion of unused putty can be saved by placing the aluminum labels on the exposed end and put back
into the cylinder.
***Note: 1.3oz PC Plumbing™ does not come with Plastic cylinder.
Fiberglass, PVC, copper, metal pipes and more.
View All Uses
- Color (Component a):
- Color (Component B):
- Work Time (70°F):
- 3 Minutes
- Cure for Service:
- 60 Minutes
- Conduction (Electric):
- Non Conductive
- Non Toxic Once Cured
- Tensile Shear Strength
- ASTM D 1002
- 650 PSI
- Compressive Yield
- ASTM D 695
- 12000 PSI
- Hardness Shored
- ASTM D 2240
- 75-85 (1wk)
- Heat Deflection
- ASTM D 648